If you want to assess the atmospheric corrosivity category according to ISO 9223 (outdoor; C1‒CX) or ISO 11844-1 (indoor; IC1‒IC5), choose the material specified in the standard.

If you want to monitor air corrosivity towards a specific material, choose a sensor with the composition similar to the material of your interest.

In less corrosive environments, you obtain the best sensitivity and reasonable longevity when using the lower corrosivity CorrSen sensors.

In harsh environments, the high corrosivity CorrSen sensors should be used.

Is the monitoring site easily accessible and large enough to place there the whole logger? If yes, choose the basic sensor modification with a sensor inserted to the logger.

If not, choose the sensor soldered on a 2-meter long cable. Note that the temperature and relative humidity measurement is not possible for this modification.

Continuous data transmission thorough integrated GSM

Up to ten loggers connected to one gate

Perfect solution for a large number of stationary placed loggers

Necessary for the real-time warning of corrosivity increase

Gate has to be plugged-in and placed in a safe environment

Ideal for remote locations without permanent power source and GSM

Low-cost solution

Applicable for a small number of loggers

Data not available in real-time

Physical presence of an operator is required to download the data

iOS application under development